Skip to main content

When using Machine Speed tab on Machine Properties, Trend values should receive speed for External Speed Input or Constant Speed

Machine Speed tab only applies speed to dynamic data.  This makes sense when using Calculated speed from spectrum.  But if user has External Speed Input or Constant speed selected, then the trend values should also be tagged with the speed.  

1 Votes

Comments

2 comments

Date Votes

    Could you clarify the use-case? If a user has selected External speed input, there will be a trend on that point. So it's a bit unclear what the request is about. Would be great if you could give us an example of a situation where the current way is not sufficient

    Also, if this is for IMx-1, constant speed should already work?

    The use case is where the external speed is coming from OPC UA and could be for either IMx-1 or IMx-8/16.  Currently the speed configured on Machine Speed tab for the Machine is only tagged to the dynamic data.  I want the speed to also be tagged to the trend type data when using E.  It makes sense that the speed was only applied to dynamic when it had to be extracted from the dynamic.  With OPC UA, the speed is always available to apply to both trend and dynamic.  

Please sign in to leave a comment.