Create SKF Multilog On-line System IMx Orbit and SCL Points in SKF @ptitude Analyst

Orbit and shaft center line (SCL) points are used to display shaft motion when monitoring turbo machinery faults and to diagnose machine problems († fig. 1). This procedure will show how to create and set up SKF Multilog IMx orbit and SCL points in SKF @ptitude Analyst software.

Please refer to the following application notes for detailed information on system setup and other points configuration:

• CM3157, Start up Guide for SKF Multilog On-line System IMx and SKF @ptitude Analyst
• CM3158, Add SKF Multilog On-line System IMx Points in SKF @ptitude Analyst
• CM3159, Add SKF Multilog On-line System IMx AC, DC, Logic and Speed Points in SKF @ptitude Analyst