Start Up Guide for SKF Multilog On-line System IMx with SKF @ptitude Analyst

Introduction

The purpose of this application note is to provide the basis for implementing a successful installation of the SKF Multilog On-line System IMx in conjunction with SKF @ptitude Analyst software.  The instructions described in this procedure cover standard conventions used in industry and aim to allow the user to verify proper system operation.

  This procedure requires SKF @ptitude Analyst 2010 Edition or later

 

This application note covers the following areas

• SKF Multilog IMx Network
• Online Device Configurator and serial interface
• SKF Multilog IMx Service
• SKF Multilog IMx unit and channels configuration in SKF @ptitude Analyst
• Firmware

Refer to the following application notes

...for detailed information about POINT configuration and other features

• CM3158: Add SKF Multilog On-line System IMx Points in SKF @ptitude Analyst
• CM3159: Add SKF Multilog On-line System IMx AC, DC, Logic and Speed Points in SKF @ptitude Analyst
• CM3160: Create SKF Multilog On-line System IMx Orbit and SCL Points in SKF @ptitude Analyst
• CM3161: Create Alarm Groups, Set up Relays and Active Ranges for SKF Multilog On-line System IMx in SKF @ptitude Analyst
• CM3171: Create SKF Multilog On-line System IMx Transient Groups for Run up and Coast down Data Collection in SKF @ptitude Analyst and SKF @ptitude Observer